Bluelab Dosetronic Peridoser Kit Uživatelský manuál stáhnout pdf (Strana 35)

Version P1.3 : 151012

Bluelab Dosetronic Peridoser Kit

Bluelab Corporation LimitedBluelab Corporation Limited

1 2

Maintenance

5.1 Conductivity probe cleaning

Over time, nutrient salts build up on the face of

the conductivity probe. This effects conductivity

readings so the face of the probe must to be cleaned

at least once a month.

1. Remove shroud by holding the body and pulling

away the shroud.

2. Using the Bluelab conductivity probe cleaner or an

unscented liquid scourer such as Jif or Sof t Scrub

place one or two drops onto the probe face.

3. Using a ﬁ nger or Bluelab chamois, rub ﬁ rmly and

vigorously to clean probe face.

4. Check that water forms an even ﬁ lm across the

surface of the probe. If beading of water is present,

clean again. Beading indicates the presence of oil on

the probe surface. This effects readings.

5. Reﬁ t the shroud and test in 27.7 CF/ 2.77 EC

solution. If reading is out it can be edited in

calibration mode. See page 26 for calibration

information. Always clean probe before calibrating.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42 43

Žádné komentáře

Bluelab Dosetronic Peridoser Kit Uživatelský manuál Strana 35